Table of Contents
Advertisement
Description
Over temp LED
Amp Status LED
Power cap LED
1
For Networking Choice (NC) server models, the embedded NIC ports are not equipped on the server. Therefore, the NIC LEDs on the
Systems Insight Display will flash based on the FlexibleLOM network port activity. In the case of a dual-port FlexibleLOM, only NIC LED
1 and 2 will illuminate to correspond with the activity of the respective network ports.
When the health LED on the front panel illuminates either amber or red, the server is experiencing a health event. For
more information on the combination of these LEDs, see Systems Insight Display combined LED descriptions).
Systems Insight Display combined LED descriptions
The combined illumination of the following LEDs indicates a system condition:
•
Systems Insight Display LEDs
•
System power LED
•
Health LED
Systems Insight Display LED
and color
Processor (amber)
Processor (amber)
DIMM (amber)
Status
Off = Normal
Amber = High system temperature detected
Off = AMP modes disabled
Solid green = AMP mode enabled
Solid amber = Failover
Flashing amber = Invalid configuration
Off = System is in standby, or no cap is set.
Solid green = Power cap applied
Health LED System power
LED
Red
Amber
Amber
Green
Red
Green
Status
One or more of the following conditions
might exist:
•
Processor in socket X has failed.
•
Processor X is not installed in the
socket.
•
Processor X is unsupported.
•
ROM detects a failed processor during
POST.
Processor in socket X is in a pre-failure
condition.
One or more DIMMs have failed.
Component identification
Table Continued
14
Advertisement
Table of Contents
