Removing The Top Cover - Xerox ii LINXSolid Inkjet 100 Service Manual

Removing the Top Cover

NOTE: Vacuum dust out of the top cover before you remove it.
1. Remove the right cover.
2. Remove the left cover.
3. Open the ink load door and tilt it back. Unclip the ink load
door arms from the ink loader's spring crossarm.
4. Slide the ink loader's spring crossarm to the rear of the ink
loader. Note how pins on the ends of the ink-loader crossarm
align with notches in the top cover for removal.
5. Remove the four screws securing the top cover in place.
6. Tilt up the rear-end of the top cover and lift and remove the top
cover.
Reverse these steps to install the top cover.
Top
cover
Figure 6-2. Removing Top Cover
840-4-04
Removal and Replacement 6-5