Xerox ii LINXSolid Inkjet 100 Service Manual page 235

Removing Stripper Finger Assemblies
1. Remove the right, left and top covers.
2. Upper stripper finger assembly. At the right side of the printer,
remove the transfix solenoid bracket.
3. Remove the cutting screw securing the right end of the upper
stripper finger assembly to the printer frame. Remove the
upper stripper finger assembly.
4. Lower stripper finger. At the right side of the printer, remove
the C-clips securing the spring unit in place. Remove the
spring unit, spring and bushing.
5. At the left side of the printer, remove the C-clip securing the
left end of the lower stripper finger assembly. Carefully
remove the bushing and lower stripper finger without
damaging the dust cover underneath.
Reverse these steps to install the stripper finger assemblies.
Removal and Replacement 6-45