Xerox ii LINXSolid Inkjet 100 Service Manual page 86

4,000: PC Processor Control Supervisor (continued)
Front Panel Software Error Code
Display
PC_DEV_FAULT_HEAD_ADJUST_TIMEOUT
4,015.45
pc fault: head adjust timeout
(0x240f)
PC_DEV_FAULT_HEAD_NV_FORMAT
4,016.46
pc fault: printhead NVRAM format
(0x2410)
PC_DEV_FAULT_AMBIENT_TOOCOLD
4,017.47
pc fault: tempt too cold
(0x2411)
PC_DEV_FAULT_LATE_CLEAN_REQUEST
4,018.48
pc fault: late clean request
(0x2412)
PC_DEV_FAULT_FTTR_HEADCAP
4,020.41
pc fault: FTTR head cap contact
(0x2414)
PC_DEV_FAULT_FTTR_DIRTYDRUM
4,021.42
pc fault: FTTR dirty drum
(0x2415)
PC_DEV_FAULT_INK_OUT_DURING_FLUSH
4,022.43
_TIMEOUT
(0x2416)
pc fault: ink out timeout
2-8 ii LINX™ Solid Inkjet 100 Service Manual
Error Codes
Meaning
Timeout during head adjust. A 20 minute timer
elapsed before the exit head adjust command
was executed. The only recovery possible is to
cycle the power switch.
This head's NVRAM contains a format of data not
supported by this version of firmware. The head
or firmware must be replaced.
Ambient temperature is less than 10 degrees
Centigrade. The printer cannot be warmed up
under these circumstances.
Printhead temperature has dropped below the
head-clean-needed threshold. This condition
occurred after the warmup sequencer had
determined a head clean operation was not
needed.
Declared when the printer is booted in FTTR
mode and the head/cap contact flag is set in
NVRAM. The printer cannot run in FTTR mode
with head/cap contact because it would be
unwise to separate the two when cold. Service
requested that this be a device fault in order to
bluntly alert the service person to the condition.
Declared when the printer is booted in FTTR
mode and the drum is dirty. Reasoning that
cleaning the drum when very cold could increase
the chance of gluing media to the drum surface
and creating an ugly mess around the stripper
fingers. Service requested that this be a device
fault in order to bluntly alert the service person
to the condition.
Timeout during head flush for ink yellowing. The
printer ran out of ink and a ten minute timer
elapsed before more ink was added. The only
recovery possible is to cycle the power switch.