Xerox ii LINXSolid Inkjet 100 Service Manual page 88

7,000: Process Motor Error Codes
Front Panel Software Error Code
Display
PM_FAULT_PROCESS_MOTOR_STALL
7,002.4x
(0x3c01)
PM_FAULT_COMPOUND_GEAR_SENSOR_BAD
7,003.4x
(0x3c02)
PM_FAULT_DM_CAM_SENSOR_BAD
7,004.4x
(0x3c09)
8,000: Cap Drive and Web Sensors Error Codes
Front Panel Software Error Code
Display
CAP_FAULT_HOME_SENSOR
8,001.44
cap fault: home sensor
(0x4401)
CAP_FAULT_OVERCURRENT
8,002.45
cap fault: overcurrent
(0x4403)
2-10 ii LINX™ Solid Inkjet 100 Service Manual
Error Codes
Error Codes
Meaning
The process motor stalled during operation. This
has several possible causes, depending on what
the PM was connected to at the time of
operation.
No transitions are observed of the compound
gear sensor when the compound gear should be
turning. Perhaps the sensor is bad (it falls off
easily), or the PM to compound gear linkage is
broken.
No transitions are observed of the drum
maintenance cam sensor. The sensor may be
bad or the DM cam may be jammed.
Meaning
An expected transition of the cap home sensor
did not occur. The home sensor may be faulty, or
the cap motor may not be operating, or the cap
may be jammed and unable to move.
An overcurrent fault has been detected. Either
the cap motor is shorted, the purge pump motor
is shorted, a solenoid is shorted, or the cap
stalled. (This fault does not actually occur
because the mechanism is loose. When the cap
jams, the motor skips over teeth.) Check the
hardware.