Xerox ii LINXSolid Inkjet 100 Service Manual page 159

snug in place.
11. Install the digital gap indicator and bracket to the left side of
the printer frame and tilt arm as described in the Procedure
"Mounting the Digital Indicator Gauge". Ensure the digital
indicator is set to inches, "in."
NOTE: Always move the printhead by moving the tilt arm.
12. At the right side of the printhead, insert the right printhead
spacer between the printhead and the drum. Check the
indicator it should read 0.0070 ±0.0010 inches. Adjust the
printhead's spacing adjustment by twisting a flat-blade
screwdriver in the adjustment slot to move the printhead's
position until the indicator reads the correct value.
NOTE: Do not insert both spacers at the same time as this will only
measure the larger of the two gaps.
13. Remove the right printhead spacer and install the left spacer
between the printhead and drum. Repeat the adjustment.
Confirm the right side is still in adjustment. If not, alternate
between the two sides until both sides read 0.0070 ±0.0010
inches.
14. Remove the spacer. Snug the four locking screws using an X
pattern. Then tighten the four screws, using the same X
pattern, to 20 in.-lbs.
15. If not connected, plug the printhead's data ribbon cable and
power wiring harness into the power control board. Inspect
both ends of the data ribbon cable to ensure they are properly
seated.
16. Recheck the gap at both ends of the printhead.
17. Remove the digital indicator gauge and bracket from the frame.
18. Reinstall the ink loader and metal heat cover.
Adjustments 4-15