Attaching The Microphone (Provided); Attaching The Microphone (Optional) - JVC GY-DV5000 Instructions Manual

3. BASIC SYSTEM CONNECTIONS AND ADJUSTMENTS

3-4 Attaching the Microphone (Provided)

1.3.
Microphone cable Cable clamp
VF

3-5 Attaching the Microphone (Optional)

2,4.
3.
FRONT AUDIO INPUT Microphone cable
4.
2.
5.
6.
KA-A50
Microphone holder
1.
MV-P615U/MV-P618U
6.
5.
Connect the provided microphone to the viewfinder. The
provided microphone is a phantom microphone.
1.
Loosen the stopper screw on the viewfinder.
2.
Attach the microphone to the attachment guide on the
viewfinder as illustrated.
3.
Confirm that there is no gap between the microphone and
the viewfinder, and then tighten the stopper screw.
4.
Tighten the screw on the microphone. The microphone
should be firmly attached.
5.
Connect the cable from the microphone to the FRONT
AUDIO IN connector on the camera.
6.
Secure the microphone cable using the cable clamp
provided on the front side of the microphone holder.
MEMO:
When attaching the viewfinder for use with the left eye,
the provided microphone cannot be attached. In this case,
use the optional microphone holder KA-A50 and
microphones MV-P615U/618U (phantom microphone).
With the optional KA-A50 microphone holder, the optional
microphones MV-P615U (phantom microphone) and MV-
P618U (phantom microphone) can be used.
<Attaching the Microphone Using KA-A50>
1.
Secure the microphone holder with 2 screws.
2.
Turn the small knob located on the outer side of the
microphone holder counterclockwise to loosen it, and loosen
the large knob located on the inner side in the same way.
Rotate the large knob fully counterclockwise to open the
holder.
3.
Attach the microphone to the microphone holder at the
designated place so that the microphone does not interfere
with the cassette cover.
4.
Set the microphone holder so that the height is level, and
tighten the inside and outside knobs to secure the
microphone.
5.
Connect the microphone cable to the FRONT AUDIO IN
connector.
● When the microphone is connected to REAR AUDIO IN
connector on the rear panel, set the CH-1 or CH-2 AUDIO
input selector switch to REAR.
6.
Secure the microphone cable using the cable clamp located
on the front side of the microphone holder.
7.
Make sure to perform the correct settings for use of a
phantom microphone.
See "FRONT/REAR AUDIO INPUT switch
15.
CAUTION:
● When the light mounted on the camera is used at the
same time, if the microphone in use has a long sound
collecting section, the microphone's shadow may appear
in the image.
!
" on page
31