JVC GY-DV5000 Instructions Manual page 88

13. OTHERS
13-1 Alarm Indications and Actions (Cont'd)
● Warning Indications for VCR Abnormalities
Should malfunctions occur during VCR operation, the unit self-diagnoses the cause and shows the diagnose together with an
error code on the LCD monitor or in the viewfinder.
Error code
WARNING7001
DRUM MOTOR FAILURE
Error Code
0201
CONDENSATION ON DRUM
3200
LOADING FAILURE
3300
UNLOADING FAILURE
4100
CASSETTE EJECT FAILURE
TAPE DEFECTIVE
5605 ~ 5609
5702
TAPE END DET. ERROR
5802
TAPE BEGIN DET. ERROR
7001
DRUM MOTOR FAILURE
7101
CAP MOTOR FAILURE
7202 ~ 7203
SUPPLY REEL FAILURE
7302 ~ 7303
TAKE UP REEL FAILURE
7305
TAKE UP REEL FAILURE
7401
REEL MOTOR FAILURE
TURN POWER OFF.
TURN BACK ON LATER.
TALLY lamp
Blinks when remaining battery power or tape is low. (Only in Camera mode)
Blinking Pattern
● Remaining battery power is low.
Slow blinking
● Remaining tape time is equivalent to less than 3 minutes.
(once per sec.)
● Tape has run out.
Fast blinking
● Irregularity has occurred in the VCR.
(four times per sec.)
88
Warning
Error Details
Indicates dew formation
(condensation)
Tape cannot be loaded.
1
*
Tape cannot be unloaded.
Irregularity with eject
operation.
Tape is cut.
Tape end sensor error.
Tape beginning sensor
error.
Drum rotation error.
Capstan rotation error.
Supply reel rotation error.
1
*
Take up reel rotation error.
1
*
Irregular tape winding
when unloading.
Reel motor rotation error.
System error when power
is turned on.
Remaining Battery/Tape
1 If the unit is used in a state where the cassette cover is
*
open after inserting a cassette tape, there can be a
case where an error code "3200, 7202, 7302" appears.
In such a case, switch off the power once and switch it
on again, and then close the cassette cover before use.
GY-DV5000 Operation
Operation stops. All operations
are rejected.
Operation stops.
Operation stops. All operations
are rejected.
MODE indicator and TALLY
lamp flash. Only Power switch
operation is accepted.
Remedy
Leave the unit with the power ON,
until the indication disappears.
Switch the power OFF and then
switch it back ON. However, the
tape may be damaged depending
on the circumstances. Please
consult the person in charge of
professional video equipment at
your nearest JVC-authorized
service agent.
Press the EJECT button to take
out the cassette.
Switch the power OFF and then
switch it back ON. However, the
tape may be damaged depending
on the circumstances. Please
consult the person in charge of
professional video equipment at
your nearest JVC-authorized
service agent.
Turn off the power and let the unit
sit for sometime befor turning it
back on.