Recording Time Codes In Continuation Of Time Codes Recorded On Tape; Reproducing Time Codes - JVC GY-DV5000 Instructions Manual

10. TIME CODE OPERATION

10-3 Recording Time Codes in Continuation of Time Codes Recorded on Tape

The GY-DV5000 also incorporates a time code reader. Therefore, when the unit enters record mode from record-standby mode, it
can read the time code data recorded on the tape and record time codes in continuation of the existing data. The recorded user's
bit data are identical to the user's bit data recorded on tape.
● However, approximately ±1-frame variations may occur in scene accuracy.
To enable this function, set the time code related switches as follows before starting recording.
OPEN
LCD BRIGHT DISPLAY
AUDIO
PULL
LEVEL
OPEN
FRONT
REAR
CH-1 CH-2
CH-1 CH-2
AUDIO INPUT
AUDIO SELECT
CH-1 CH-2
AUTO
MANUAL

10-4 Reproducing Time Codes

The GY-DV5000 incorporates a time code reader. During playback, the time code or user's bit data recorded on the tape is
displayed on the LCD monitor or in the viewfinder. (Status screen)
PLAY 01/02/03 01:23:45
Status screen
64
LCD BRIGHT DISPLAY
MONITOR
SELECT
COUNTER
CH-1
FRONT
MIX TC
CH-2 REAR
UB
AUDIO CH-1 CH-2
CH-1 CH-2
LEVEL AUDIO INPUT
AUDIO SELECT
AUDIO INPUT
TC GENE.
FRONT REAR CH-1 CH-2
LINE AUTO REGEN FREE
REC
MIC MANUAL
+48V
PRST
TC GENE switch
Playback time code indication
00:00:00:00
12.2V
Setting
Set the TC GENE switch inside the cover on the side to
REGEN.
● The time code framing mode automatically becomes the
mode (drop frame or non drop frame) already recorded on
the tape.
Setting
See "Displaying Time Code" on page 62.
CAUTION:
A time code with a duration of more than 2 hours may not
be displayed correctly by DV components for general
consumer use, as some of these lack the capability to
display longer time codes.