Rear Section - JVC GY-DV5000 Instructions Manual

2. CONTROLS, INDICATORS AND CONNECTORS

2-5 Rear Section

y
t
1
[TALLY] Tally lamp
This lamp lights up when the GY-DV5000 enters the record
mode. It blinks during the transition to the record mode.
● Use the BACK TALLY item on the OTHERS (2/2) menu
screen to select whether or not the lamp should light and
the lighting pattern.
See "BACK TALLY" on page 78.
2
[REAR AUDIO IN] Audio input connector on the
rear section
Connect external audio equipment or a microphone to this
connector.
● Set the FRONT/REAR AUDIO INPUT switch
15 in accordance with the connected equipment.
● To record the audio signal input through this connector,
set the CH-1 or CH-2 AUDIO INPUT switch
15 to "REAR". The audio from this connector is recorded
on the channel set to "REAR".
2 1
3
3
[DC IN] DC input connector (XLR 4-pin)
Power input connector for 12 V DC. Connect to the optional
AA-P250 power adapter. When a cable is connected here,
the power supply from the battery pack is interrupted and
the source is switched to the power supplied through this
connector.
18
u
PHONES DV REAR AUDIO IN TALLY q
DC IN
DC OUT
r e w
!
on page
0
on page
No. Signal
1 GND
2 HOT
3 COLD
i
PUSH
LINE OUT
CH-1
Y/C OUT MONITOR OUT
CH-2
1
4
[DC OUT] DC output connector
Connector for power output to a wireless microphone
transmitter, etc. The supply voltage is identical to the voltage
supplied to the unit (DC 17 V max. 0.3 A).
4
3
(Surface profile)
5
[PHONES] Earphone jack
This is a stereo mini-jack for connecting an earphone for
audio monitoring. Plug in an earphone or headphone with
a 3.5 mm diameter plug. The earphone can also be used to
monitor alarm tones in accordance with the circumstances.
The sound from the monitoring loudspeaker is interrupted
when an earphone is connected here.
The audio channel to be output is selected with the AUDIO
SELECT item on the AUDIO/VIDEO menu screen and
MONITOR SELECT switch
The audio output level is adjusted with the Audio monitor
volume control
o
No.
1
2
4
3
2 3
4
1
No.
1
GND
2 —
3
—
4
DC 12V (power through)
2
@
on page 15.
1
on page 12.
Signal
GND
—
—
+12V
Signal