Initializing The Machine - Ricoh B234 Service Manual

COPIER (B234/B235/B236/D101/D102/D103)

Initializing the Machine

Important:
• Before you do this procedure, make sure that the front doors of the machine are
closed.
1. Plug in the power cord and turn the main switch on.
2. Install the toner bottles.
3. When the machine is ready, enter SP mode:
1) Press .
2) Enter "107".
3) Hold down
4. Press "Copy SP" on the LCD, and perform the TD initial setting:
1) Select SP2801 (TD Sensor Initial Setting)
2) Use the keys displayed on the screen and the numeric keys on the LCD to
enter the developer Lot No., then press
NOTE: The Lot No. is embossed on the top edge of the developer packet.
3) Press "Execute" on the LCD.
NOTE: This executes the TD initial setting. After about 1 minute, "Completed"
is displayed on the screen, and the execution stops automatically.
5. Start to supply toner from the toner bank to the toner hopper:
1) Select SP2207 002 (Toner Bank Toner Setup).
2) Press "Execute" on the LCD.
This procedure supplies toner to the toner hopper and the toner transport path.
It will stop automatically in about 6 minutes. If SP2207 002 fails after SP2801 is
completed (an SC code is displayed), repeat only SP2207 002.
6. Execute SP2962 (Auto Process Control Execution).
NOTE: In step 2, if you enter SP mode immediately after switching the machine
on, the system will not execute process control automatically. To
ensure that process control calibrates its settings, use this SP to
execute process control manually.
If SP 2962 fails, the setting of 3901 001 (auto process control setting)
changes from 'on' to 'off'.
B234/B235/B236/D101/D102/D103
for more than 3 seconds.
1-30
.
SM