PROGRAM DOWNLOAD
4.1.3
DOWNLOAD ERROR CODES
Display
01
Reboot after
card insert E01
↕
Module ID
Card No. xx/xx
02
Download Error E02
Power off/on
03
Download Error E03
Power off/on
04
Download Error E04
Power off/on
05
Download Error E05
Power off/on
06
Download Error E06
Power off/on
19
Download Error E19
Power off/on
20
Down Error E20
Power Off/On
21
Download Error E21
Power Off/On
B234/B235/B236/D101/D102/D103
Details
Controller ROM update error 1
When the update break data is stored in
NVRAM, the break module information and
the decompression module capable of
writing do not match.
Controller ROM update error 2.
Error occurs during ROM update program
initialization.
Controller ROM update error 3
The ROM for the write operation does not
exist.
Controller ROM update error 4
GZIP data confirmation fails. (CRC value
check)
Controller ROM update error 5
Error occurs when writing to the device.
Controller ROM update error 6
CPU clock error.
Controller ROM update error 7
Schedule data is unclear.
System error 1 (+SC991)
The physical address cannot be mapped.
Software/hardware is defective
System error 2 (+SC991)
There is not sufficient memory to
download.
4-2
Recovery
• Use the correct card
• Cycle the machine
off/on to rewrite
• Cycle the machine
off/on
• Install the missing ROM
DIMM
• Cycle the machine
off/on
• Set DIP SW 1 to ON
and retry
• Replace RAM DIMM
• Replace controller board
• Cycle the machine
off/on
• Set DIP SW 1 to ON
and retry
• Replace RAM DIMM
• Replace controller board
• Turn the machine power
off/on.
• Set controller DIPSW-1
to ON to force the
machine to write to
ROM.
• If you cannot force the
machine to write,
replace the controller
board.
• Software defective
• Cycle the machine
off/on and re-try
• Replace controller board
• Cycle the machine
off/on and re-try.
• Replace RAM
• Replace the controller
board
SM