Ricoh B234 Service Manual page 146

PUNCH UNIT PU5000 (B831)
[C]
14. Connect the PCB harness connector [A] to CN135 of the finisher PCB and to
CN600 of the punch unit PCB.
15. Connect the harness [B] to CN136 of the finisher PCB.
16. Connect the single end of the hopper full sensor connector cable [C] to the
hopper full sensor on the arm (
NOTE: No special DIP switch settings are required for this punch unit. A signal
from the punch identifies itself by sending a signal to the copier.
17. Slide the punch waste collection hopper [D] into the finisher.
18. Re-attach the inner cover and rear cover.
19. Close the front door and re-connect the finisher to the machine.
B234/B235/B236/D101/D102/D103
[A]
[B]
B831I107.WMF
x 1,
1-108
[D]
x 2).
B831I109.WMF
SM