Ricoh B234 Service Manual page 520

SERVICE CALL CONDITIONS
SC860 D HDD Error 1
The driver could not acquire the status of the
hard disks within 30 s, or the HDD is
connected, but the driver detected one of the
following errors:
SS_NOT_READY
SS_BAD_LABEL
SS_READ_ERROR
SS_WRITE_ERROR
SS_FS_ERROR
SS_MOUNT_ERROR
SS_COMMAND_ERROR
SS_KERNEL_ERROR
SS_SIZE_ERROR
SS_NO_PARTITION
SS_NO_FILE
SC861 B HDD Error b2: HDD Startup
The hard disks were
detected at power on, but
the disks were not detected
within 30 s after recovery
from the energy
conservation mode.
SC862 A HDD Error 3: Bad Sectors
The number of bad sectors
on the HDD in the area for
storing images exceeds
101.
SC863 B HDD Error 4: HDD Read Error
The system cannot read the
data written on the hard
disks.
SC864 B HDD Error 5: Data CRC Error
During HDD operation, the
HDD could not respond to a
CRC error query.
B234/B235/B236/D101/D102/D103
One or both HDDs are not ready.
Partition types are different
Error returned during label read or label check
Error returned during label write or label check
File system repair failed
File system mount failed
Drive does not answer the command
Kernel internal error
Driver size is too small
Specified partition does not exist
Device files do not exist
• Cable between the hard disks and controller
board disconnected or loose
• Hard disk power connector loose
• One of the hard disks is defective
• Controller or mother board defective
• Too many bad sectors accumulated on the
HDDs.
• Execute SP5832 002 (HDD Formatting – IMH)
to format the HDD and replace the bad
sectors; copy the stamp data after doing this
(use SP 5853).
• HDD replacement is recommended because
an HDD unit that generates bad sectors is
probably of poor quality and performs poorly.
• Sectors on the disks have become corrupted
during operation; replace the hard disks
• Mother board defective
4-100
• Hard disks are not formatted
• Hard disk corrupted; reformat
the disks with SP mode
SM