2Nd Fold Adjustment - Ricoh B234 Service Manual

REPLACEMENT AND ADJUSTMENT

2nd Fold Adjustment

1. Print one A3 copy and send it through the Z-
fold unit.
2. Open the folded sheet at the 1st fold
lay it down flat.
3. Stand the sheet on its end so the edge
up and the crease of the 1st fold is facing
out.
4. Open the left door and locate the screw that
adjusts the 2nd fold (see previous page).
5. Use a plus screwdriver to turn the screw [A]
to the left to loosen the nut.
• If the corner is over the right edge, turn
the screw to the right.
• If the corner is over the left edge, turn the
screw to the left.
NOTE:
• The illustration shows the corner over the
right edge.
• You can see the pointer [B] change
position on the notches of the adjustment
scale as you turn the screw.
6. Close the Z-Fold unit.
7. Do another test print.
8. If the 1st fold is still misaligned, repeat
this procedure until the alignment is
correct.
9. After the adjustment is completed, use
a screw driver to hold the screw in
position, then retighten the nut you
loosened in Step 2. Do not turn the
screw.
B660
then
is
3
16
1
2
B660R225.WMF
[B]
[A]
B660R230.BMP
3
SM