Maintenance; Maintenance Schedule - Husqvarna Rider ProFlex 21 II Operator's Manual

Maintenance

Maintenance Schedule

The following is a list of maintenance procedures that must be performed on the Rider. For points marked
with footnote number 4, turn to an authorised service representative.
Maintenance
Check for fuel and oil leakages
Check the parking brake
Check the engine's oil level (every refuelling)
Check the fuel pump's air filter
Check the safety switch, seat
Check the safety switch, lifting lever
Check the safety switch, pedal system
Check/clean the engine's cooling air intake
Check the cutting unit:
• attaching the blades
• condition of the blades (sharpness, shape, etc.)
Check the steering cables (looseness, etc.)
Check fastenings (screws, nuts, etc.)
Start the engine and blades, listen for unusual
sounds
Clean under the cutting unit
Clean the transmission's cooling air intake
Check the battery's acid level
Check the transmission oil level
Check the condition of belts, belt pulleys, etc.
Check for damage
Check the air pressure in the tyres (60 kPa)
Check to ensure that the cable guides in the
middle are undamaged
Clean thoroughly around the engine
Clean thoroughly around the transmission
Clean around all belts, belt pulleys, etc.
Lubricate the differential lock cable
Lubricate the three-point link (nipple)
Lubricate the driver seat
Lubricate all cables
Lubricate the safety catch in the cutting unit
Lubricate the interior plug in the cutting unit
Lubricate the groove for the cutting unit's
equipment frame
Lubricate links in the cutting unit
Clean the frame tunnel
Lubricate the pedal mechanism in the frame
tunnel
MAINTENANCE
Page Daily
maintenance
before after
33
50
35
37
37
37
29
40
42
42
30
-
19
41
29
36
53
-
-
33
32
-
-
48
49
51
51
48
51
51
51
51
-
48
Weekly At least Maintenance interval
3
main- once a in hours
tenance year
25 50 100 300
25
English-