Table of Contents
Advertisement
Checking and Adjusting the
Steering Cables
The steering is governed by means of cables.
After a period of use these can become
stretched, which means the steering setting
may have changed.
Steering is checked and adjusted as follows:
1.
Remove the frame plate by loosening the
screws (two on the steering servo
housing).
2.
Ensure that the cables are properly
situated under the steering cable pulleys
in the frame tunnel.
Check the tension of the steering cables
by squeezing the cables together (at the
arrows). It should be possible to squeeze
the cables so that the distance between
them is half the size, without using too
much force.
Change the cable if it has a damaged
strand causing loose threads to protrude.
3.
If necessary, the cables can be streched
by first loosening the lock nut and then
tightening the adjuster nuts (one cable
on each side of the machine).
Hold the cable with, for example, a
wrench so that it does not twist. If the
adjustment is only made on one side, the
middle position of the steering will be
affected.
Do not over tighten the cables, they
should only be drawn in towards the
steering collar.
Check the cable tension after you have
made the adjustment as described in
point 2.
MAINTENANCE
8009-340
6008-212
8009-341
29
English-
Advertisement
Table of Contents
Troubleshooting
