Fiber Optic Cable - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

Figure 45: Properly Installed and Bundled Cable

Fiber Optic Cable

Fiber optic cable must be handled carefully during installation. Every cable has a minimum bend
radius, for example, and fibers will be damaged if the cables are bent too sharply. It is also important
not to stretch the cable during installation. We recommend that the bend radius for fiber optic cable
equal 2 inches (5.08 cm) minimum for each 90 degree turn as shown in
NOTE
Kinks and sharp bends can destroy or impair the cable's ability to convey light pulses accurately from one
end of the cable to the other. Use care in dressing the optical fiber cables: provide satisfactory strain relief to
support the cable and maintain an adequate bend radius at all cable turns, particularly where the cable connects to
the I/O module.
BlackDiamond 8800 Series Switches Hardware Installation Guide
Cable managers supporting
and directing cables
Proper
bundling
of cables
Adequate
slack, and
bend radius
SPG_008
Figure 46.
81