Module Slot Assignments; Chassis And Slot Compatibility Issues For 8900 Series Modules - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

Installing Modules and Establishing Initial Management Access

Module Slot Assignments

The specific slot locations for I/O modules and MSMs in the chassis are as follows:
BlackDiamond 8810 switch
●
- Slots 1, 2, 3, 4, 7, 8, 9, and 10 can accommodate only I/O modules.
- Slot 5/A can accommodate only an MSM.
- Slot 6/B can accommodate an MSM or I/O module, with the exceptions noted in
page 114.
BlackDiamond 8806 switch
●
- Slots 1, 2, 5, and 6 can accommodate only I/O modules.
- Slot 3/A can accommodate only an MSM.
- Slot 4/B can accommodate an MSM or I/O module, with the exceptions noted in
page 114.
NOTE
The slots listed below will operate only an MSM:
- Slot 5/A in the BlackDiamond 8810 chassis
- Slot 3/A in the BlackDiamond 8806 chassis
MSMs reside in different slots depending on which BlackDiamond switch you operate:
If you are using only one MSM in the BlackDiamond 8806 switch, install that MSM in slot 3. If you
●
add a second MSM to increase reliability and throughput, install the second MSM in slot 4.
If you are using only one MSM in the BlackDiamond 8810 switch, install that MSM in slot 5. If you
●
add a second MSM to increase reliability and throughput, install the second MSM in slot 6.

Chassis and Slot Compatibility Issues for 8900 Series Modules

Slot 6/B in the BlackDiamond 8810 chassis and slot 4/B in the BlackDiamond 8806 chassis
accommodate either an MSM or an I/O module. However, when you use 8900 series modules, certain
combinations of model series and type are not supported (see
Table 21: 8900 Series Module Combinations in Dual-Use Slots
If Slot 3/A or 5/A
(MSM only) contains . . .
8900-MSM128
MSM-G8X of MSM-48
MSM-48c
Do not install 8900 series I/O modules in any slot of a BlackDiamond 8810 chassis that has a
manufacturing part number of 800129-00 (revision 10 or earlier). (Most of these chassis models are
labeled Aspen instead of BlackDiamond.) To verify the part number and revision, use the
CLI command. This compatibility issue affects only I/O modules.
114
Slot 4/B or 6/B (Dual-Use)
can contain . . .
8900-MSM128 only
MSM-G8X or MSM-48
Any 8800 original, a, c, or
e series I/O module
MSM-48c
Any 8800 original, a, c, or
e series I/O module
BlackDiamond 8800 Series Switches Hardware Installation Guide
Table 21).
Slot 4/B or 6/B (Dual-Use)
cannot contain . . .
Any I/O module
8900-MSM128
8900 series I/O module
MSM-G8X, MSM-48, or
8900-MSM128
8900 series I/O module
Table 21 on
Table 21 on
show version