Logging Into And Exiting A Privilege Level; Controlling Access Point Access With Radius - Cisco Aironet 1100 Series Installation And Configuration Manual

Chapter 6 Administering the Access Point
Command
Step 4 end
Step 5
show running-config
or
show privilege
Step 6 copy running-config startup-config
When you set a command to a privilege level, all commands whose syntax is a subset of that command
are also set to that level. For example, if you set the show ip route command to level 15, the show
commands and show ip commands are automatically set to privilege level 15 unless you set them
individually to different levels.
To return to the default privilege for a given command, use the no privilege mode level level command
global configuration command.
This example shows how to set the configure command to privilege level 14 and define SecretPswd14
as the password users must enter to use level 14 commands:
AP(config)# privilege exec level 14 configure
AP(config)# enable password level 14 SecretPswd14

Logging Into and Exiting a Privilege Level

Beginning in privileged EXEC mode, follow these steps to log in to a specified privilege level and to exit
to a specified privilege level:
Command
Step 1 enable level
Step 2 disable level

Controlling Access Point Access with RADIUS

This section describes how to control administrator access to the access point using Remote
Authentication Dial-In User Service (RADIUS). For complete instructions on configuring the access
point to support RADIUS, see
RADIUS provides detailed accounting information and flexible administrative control over
authentication and authorization processes. RADIUS is facilitated through AAA and can be enabled only
through AAA commands.
Note For complete syntax and usage information for the commands used in this section, refer to the Cisco IOS
Security Command Reference for Release 12.2.
OL-2851-01
Purpose
Return to privileged EXEC mode.
Verify your entries.
The first command displays the password and access level configuration.
The second command displays the privilege level configuration.
(Optional) Save your entries in the configuration file.
Purpose
Log in to a specified privilege level.
For level, the range is 0 to 15.
Exit to a specified privilege level.
For level, the range is 0 to 15.
Chapter 11, "Configuring RADIUS Servers."
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide

Controlling Access Point Access with RADIUS

6-7