Mounting On A Suspended Ceiling - Cisco Aironet 1100 Series Installation And Configuration Manual

Mounting on a Suspended Ceiling

Mounting on a Suspended Ceiling

Follow these steps to mount your access point on a suspended ceiling. It may be helpful to refer to
Figure D-2
Figure D-2
1
2
3
Determine the location at which to mount the access point.
Step 1
Attach two caddy fasteners to the ceiling's T-rail.
Step 2
Use the wall or ceiling mounting bracket to adjust the distance between the caddy fasteners so that they
Step 3
align with the holes in the bracket.
•
Step 4 Use a standard screwdriver to tighten the caddy fastener studs in place on the T-rail. Do not overtighten.
Step 5 Install a plastic spacer on each caddy fastener stud. The spacer's legs should contact the ceiling grid
T-rail.
Step 6 Attach the wall or ceiling mounting bracket to the caddy fastener studs and start a Keps nut on each stud.
Use a wrench or pliers to tighten the Keps nuts. Do not overtighten.
Step 7
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
D-4
before beginning the process.
Suspended Ceiling Mounting Bracket Parts
2
3
5
Suspended ceiling T-rail
Caddy fastener
Plastic spacer
The distance between the caddy fastener studs is 2.5 in (6.35 cm).
4
Wall or ceiling mounting bracket
5 Keps nut
Appendix D Mounting Instructions
1
2
3
4
5
OL-2851-01