Mounting On A Horizontal Or Vertical Surface - Cisco Aironet 1100 Series Installation And Configuration Manual

Appendix D Mounting Instructions
The wall or ceiling mounting bracket also serves as a template for transferring the location of the
bracket's mounting holes to the mounting surface. Refer to
holes for the method you intend to use.
Figure D-1
1
2

Mounting on a Horizontal or Vertical Surface

Follow these steps to mount the access point on a horizontal or vertical surface, such as a ceiling or wall.
Use the wall or ceiling mounting bracket as a template to mark the locations of the mounting holes.
Step 1
•
Drill one of the following sized holes at the locations you marked:
Step 2
•
•
Install the anchors into the wall if you are using them. Otherwise, go to Step 4.
Step 3
Secure the mounting bracket to the surface using the #8 fasteners.
Step 4
Note
Line up the mounting slots on the access point with the mounting rail on the mounting bracket and slide
Step 5
down the mounting rails until it clicks into place.
OL-2851-01
Mounting Bracket
1 2 3
Security hasp
Access point mounting rail
You can use any of the 10 holes around the periphery (three of which are identified in the
illustration) of the bracket to mount it using the supplied #8 fasteners.
3/16 in. (4.7 mm) if you are using wall anchors
3/32 in. (2.3 mm) if you are not using wall anchors
On a vertical surface, be sure to mount the bracket with its security hasp facing down.
4 4 3 4
3
Suspended ceiling mount holes
4 Wall mount holes
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide

Mounting on a Horizontal or Vertical Surface

Figure D-1 to locate the various mounting
D-3