Disabling And Enabling Cdp - Cisco Aironet 1100 Series Installation And Configuration Manual

Chapter 16 Configuring CDP
Command
Step 3 cdp timer seconds
Step 4 end
Use the no form of the CDP commands to return to the default settings.
This example shows how to configure and verify CDP characteristics:
AP# configure terminal
AP(config)# cdp holdtime 120
AP(config)# cdp timer 50
AP(config)# end
AP# show cdp
Global CDP information:
For additional CDP show commands, see the

Disabling and Enabling CDP

CDP is enabled by default. Beginning in Priveleged Exec mode, follow these steps to disable the CDP
device discovery capability.
Command
Step 1
configure terminal
Step 2 no cdp run
Step 3
end
Beginning in privileged EXEC mode, follow these steps to enable CDP when it has been disabled:
Command
Step 1
configure terminal
Step 2
cdp run
Step 3 end
This example shows how to enable CDP if it has been disabled.
AP# configure terminal
AP(config)# cdp run
AP(config)# end
OL-2851-01
Sending a holdtime value of 120 seconds
Sending CDP packets every 50 seconds
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
Purpose
(Optional) Set the transmission frequency of CDP updates in
seconds.
The range is from 5 to 254; the default is 60 seconds.
Return to Privileged Exec mode.
"Monitoring and Maintaining CDP" section on page
Purpose
Enter global configuration mode.
Disable CDP.
Return to Privileged Exec mode.
Purpose
Enter global configuration mode.
Enable CDP after disabling it.
Return to privileged EXEC mode.
Configuring CDP
16-4.
16-3