Configuring Filters Using the Web-Browser Interface
Figure 15-4 Apply Filters Page
Select the filter name from one of the IP drop-down menus. You can apply the filter to either or both the
Step 17
Ethernet and radio ports, and to either or both incoming and outgoing packets.
Step 18
Click Apply. The filter is enabled on the selected ports.
Configuring and Enabling Ethertype Filters
Ethertype filters prevent or allow the use of specific protocols through the access point's Ethernet and
radio ports. You can apply the filters you create to either or both the Ethernet and radio ports and to either
or both incoming and outgoing packets.
Use the Ethertype Filters page to create Ethertype filters for the access point.
Ethertype Filters page.
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
15-8
Chapter 15
Configuring Filters
Figure 15-5
shows the
OL-2851-01