Using Ipsu To Set The Access Point's Ip Address And Ssid - Cisco Aironet 1100 Series Installation And Configuration Manual

Using the IP Setup Utility

Using IPSU to Set the Access Point's IP Address and SSID

If you want to change the default IP address (10.0.0.1) of the access point, you can use IPSU. You can
also set the access point's SSID at the same time.
Note The computer you use to assign an IP address to the access point must have an IP address in the same
subnet as the access point (10.0.0.x).
IPSU can change the access point's IP address and SSID only from their default settings. After the IP
Note
address and SSID have been changed, IPSU cannot change them again.
Follow these steps to assign an IP address and an SSID to the access point:
Double-click the IPSU icon on your computer desktop to start the utility.
Step 1
Click the Set Parameters radio button in the Function box (see
Step 2
Figure 3-4
Enter the access point's MAC address in the Device MAC ID field. The access point's MAC address is
Step 3
printed on the label on the bottom of the unit. It should contain six pairs of hexadecimal digits. Your
access point's MAC address might look like this example:
004096xxxxxx
Note
Enter the IP address you want to assign to the access point in the IP Address field.
Step 4
Step 5 Enter the SSID you want to assign to the access point in the SSID field.
Note
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
3-10
IPSU Set Parameters Screen
The MAC address field is not case-sensitive.
You cannot set the SSID without also setting the IP address. However, you can set the IP address
without setting the SSID.
Chapter 3 Configuring the Access Point for the First Time
Figure 3-4).
OL-2851-01