Step 3 Configure Terminal; Step 6 End - Cisco Aironet 1100 Series Installation And Configuration Manual

Working with Software Images
•
•
For more information, refer to the documentation for your FTP server.
Downloading an Image File by Using FTP
You can download a new image file and overwrite the current image or keep the current image.
For the download and upload algorithms to operate properly, do not rename image directories.
Caution
Beginning in privileged EXEC mode, follow Steps 1 through 7 to download a new image from an FTP
server and overwrite the existing image. To keep the current image, skip Step 7.
Command
Step 1
Step 2
Step 3 configure terminal
Step 4
ip ftp username username
Step 5 ip ftp password password
Step 6 end
Cisco Aironet 1100 Series Access Point Installation and Configuration Guide
19-24
If you are accessing the access point through a Telnet session and you do not have a valid username,
make sure that the current FTP username is the one that you want to use for the FTP download. You
can enter the show users privileged EXEC command to view the valid username. If you do not want
to use this username, create a new FTP username by using the ip ftp username username global
configuration command. This new name will be used during all archive operations. The new
username is stored in NVRAM. If you are accessing the access point through a Telnet session and
you have a valid username, this username is used, and you do not need to set the FTP username.
Include the username in the archive download-sw or archive upload-sw privileged EXEC
command if you want to specify a username for that operation only.
When you upload an image file to the FTP server, it must be properly configured to accept the write
request from the user on the access point.
Chapter 19
Purpose
Verify that the FTP server is properly configured by referring
to the "Preparing to Download or Upload an Image File by
Using FTP" section on page
Log into the access point through a Telnet session.
Enter global configuration mode.
This step is required only if you override the default remote
username or password (see Steps 4, 5, and 6).
(Optional) Change the default remote username.
(Optional) Change the default password.
Return to privileged EXEC mode.
Managing Firmware and Configurations
19-23.
OL-2851-01