Using Ipsu To Find The Access Point's Ip Address - Cisco Aironet 1130AG Series Hardware Installation Manual

Using the IP Setup Utility
Select the file again to download it.
Step 8
Download and save the file to a temporary directory on your hard drive and then exit the Internet browser.
Step 9
Double-click IPSUvxxxxxx.exe in the temporary directory to expand the file.
Step 10
Double-click Setup.exe and follow the steps provided by the installation wizard to install IPSU.
Step 11
The IPSU icon appears on your computer desktop.

Using IPSU to Find the Access Point's IP Address

If your access point receives an IP address from a DHCP server, you can use IPSU to find its IP address.
Because IPSU sends a reverse-ARP request based on the access point MAC address, you must run IPSU
from a computer on the same subnet as the access point and the access point must have an IP address.
Follow these steps to find the access point's IP address:
Double-click the IPSU icon on your computer desktop to start the utility. The IPSU screen appears (see
Step 1
Figure
Figure 3-4
When the utility window opens, make sure the Get IP addr radio button in the Function box is selected.
Step 2
Enter the access point's MAC address in the Device MAC ID field. The access point's MAC address is
Step 3
printed on the label on the bottom of the unit. It should contain six pairs of hexadecimal digits. Your
access point's MAC address might look like the following example:
000164xxxxxx
Note
Click Get IP Address.
Step 4
Step 5 When the access point's IP address appears in the IP Address field, write it down.
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
3-10
C I S C O C O N F I D E N T I A L -
3-4).
IPSU Get IP Address Screen
The MAC address field is not case-sensitive.
Chapter 3 Configuring the Access Point for the First Time
D r a f t 2
OL-6226-01