Mounting Below A Suspended Ceiling - Cisco Aironet 1240AG Series Hardware Installation Manual

Mounting Below a Suspended Ceiling

Mounting Below a Suspended Ceiling
To comply with NEC code, a #10-24 grounding lug is provided on the mounting plate.
Note
You should review
Figure 2-4
1
2
3
Follow these steps to mount your access point on a suspended ceiling:
Decide where you want to mount the access point.
Step 1
Attach two T-rail clips to the suspended ceiling T-rail.
Step 2
Use the mounting plate to adjust the distance between the T-rail clips so that they align with the holes in
Step 3
the mounting plate.
Use a standard screwdriver to tighten the T-rail clip studs in place on the suspended ceiling T-rail. Do
Step 4
not overtighten.
Install a plastic spacer on each T-rail clip stud. The spacer's legs should contact the suspended ceiling
Step 5
T-rail.
Attach the mounting plate to the T-rail clip studs and start a Keps nut on each stud.
Step 6
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
2-8
D r a f t 1 A - C I S C O C O N F I D E N T I A L
Figure 2-4 before beginning the mounting process.
T-Rail Mounting Parts
2
3
5
Suspended ceiling T-rail
T-rail clips
Plastic spacer
---- TBD -----
4
mounting plate
5
Keps nut (contains an attached lock washer)
Chapter 2 Installing the Access Point
1
2
3
4
5
OL-7293-01