Fire-Lite MS-9200UD User Manual page 47

3URJUDPPLQJ DQG 3DVVZRUGV
06 8' 31   $ 
To access user Programming mode, press the Enter or Mode key. The LCD will display
the following:
1=READ STATUS MODE
2=PROGRAMMING MODE
3=MANUAL DIAL MODE
To enter the user Programming mode, press 2. The display will read as follows:
PROGRAMMING
ENTER PASSWORD
*****
Entering the Master level password (default 00000) will cause the following screen to
appear:
1=AUTOPROGRAM
2=POINT PROGRAM
3=ZONE SETUP
If the Maintenance level password (default 11111) is entered, the following screen will
appear:
1=POINT PROGRAM
2=HISTORY
3=PROGRAM CHECK
Note that in the two preceding screens, an arrow appears to inform the programmer that
additional options can be viewed by pressing the keypad down arrow key.
PROGRAMMING
PROGRAMMING
3URJUDPPLQJ