User Programming - Fire-Lite MS-9200UD User Manual

8VHU 3URJUDPPLQJ

3.2 User Programming

! ! !
See Page
06 8' 31   $ 
The MS-9200UD is completely field programmable and requires no special software
skills. While programming the MS-9200UD, the fire protection capabilities of the
control panel are enabled.
Site-specific programming may be accomplished in three ways:
• Autoprogramming Feature - This is a convenient method for quickly bringing
the FACP addressable SLC devices on-line without the necessity of
programming each device individually. Refer to "Autoprogram" on page 49 for
a detailed description of Autoprogramming
• Manual programming or editing, using the FACP keypad or a PC keyboard
• Off-line Programming and Editing Feature - allows creation and editing of site-
specific custom programs using a Windows-based computer. For programs
requiring a large amount of data entry, this method may be preferred. A PK-Plus
programming kit can be ordered for this purpose
The System All Normal screen will be displayed in a programmed system with no active
alarms, troubles or supervisories, as illustrated below:
FIRE-LITE ALARMS INC
SYSTEM ALL NORMAL
10:00A 012102
Programming, Read Status and Manual Dial mode can be entered while the panel is in
any mode of operation. If the panel is in alarm, the alarm condition must be
acknowledged before entering any other mode. To access any of the programming or
read status features, the Enter or Mode key must be pressed, which will cause the LCD
to display the following:
1=READ STATUS MODE
2=PROGRAMMING MODE
3=MANUAL DIAL MODE
Pressing 1, while this screen is being displayed, will cause the control panel to enter the
Read Status Mode which allows the user to view the programmed features and status of
the control panel The Read Status feature is not password protected. Refer to "Read
Status" on page 141 for a detailed description of this feature.
Pressing 2 will select user Programming Mode which may only be accomplished by an
authorized person. After pressing 2, a screen will prompt for a password. After
entering the correct password, the user may select from a list of programming options.
Pressing 3 will select the Manual Dial Mode which allows the user to enter a
troubleshoot mode of operation.
Exit Programming, Read Status and Manual Dial Mode
The programmer can exit any mode by repeatedly pressing the keypad ESC (Escape)
key until the display reads System All Normal. Note that the data which is entered
during Programming mode is not saved until the programmer exits this mode by
repeatedly pressing the 'ESC' key. If the Reset key is pressed or power is lost before
exiting Programming mode, all data just entered will be lost.
3URJUDPPLQJ