Maintenance Programming Level
3.7 Maintenance Programming Level
MS-9200UD PN 51906:A 12/10/02
To access Maintenance Programming mode, press the Enter key. The LCD will display
the following:
1=READ STATUS
2=PROGRAMMING
To enter the Maintenance Programming mode, press 2. The display will read as
follows:
PROGRAMMING
ENTER PASSWORD
When the Maintenance level password (default 11111) is entered, the following screen
will appear:
1=POINT PROGRAM
2=HISTORY
3=PROGRAM CHECK
Note that in the preceding screens, an arrow appears to inform the programmer that
additional options can be viewed by pressing the keypad down arrow key, as shown in
the following screen.
1=WALKTEST
2=SYSTEM
3=ZONE SETUP
PROGRAMMING
PROGRAMMING
Programming
121