Running A Software Update For The Otmc 100; Performing A Reboot Of The Otmc 100 - Omicron Lab OTMC 100 User Manual

OTMC 100 Series User Manual
Perform a factory reset on the device if you forgot your password (see "Operating
Procedures Performed at the Device" on page 31).
6.1.3

Running a Software Update for the OTMC 100

Please note that the OTMC 100 will not deliver time information during a software update.
1. Click the Tools icon in the navigation bar of the Web Interface.
2. Click the Software Upgrade icon.
3. Click the Browse... button to navigate to the software image file and select it.
4. Deselect the Keep settings check box if you want to reset the device configuration to the factory
defaults after the software update. If the check box is selected, the user specific configuration
settings are kept during the software update.
5. Click the Update button to start the software update.
6. The update process may take several minutes. Do not disconnect the OTMC 100 or the computer
during this process.
7. The OTMC 100 automatically restarts after the software update has completed.
If the software update process fails due to any reason, the OTMC 100 enters a recovery
mode on the next power-up. In this mode, the device provides only a rudimentary Web
Interface (similar to the Software Upgrade page) just allowing for the upload of a software
image (see "Operating Procedures Performed at the Device" on page 31).
6.1.4

Performing a Reboot of the OTMC 100

A device reboot can also be performed directly on the device (see "Operating Procedures
Performed at the Device" on page 31).
1. Click the Tools icon in the navigation bar of the Web Interface.
2. Click the Device Control icon.
3. Click the Reboot button next to Reboot device.
4. The OTMC 100 performs a reboot. The device will be ready for operation again after approx. 15 s.
28