Accessing The Otmc 100 From A Computer; System Requirements; Accessing The Otmc 100 Web Interface - Omicron Lab OTMC 100 User Manual

Omicron lab antenna-integrated ptp grandmaster clocks

Hide thumbs Also See for OTMC 100:

Table of Contents

5.2

Accessing the OTMC 100 from a Computer

The OTMC 100 automatically powers up after supply voltage is provided via Ethernet (PoE). The LED

lights up green when the device is ready for operation.

After that, a network IP address is assigned automatically in order to connect the device to the

network. If a DHCP server is available in the network, the IP address is assigned by the DHCP server.

If not, the OTMC 100 automatically selects and assigns a link-local IPv4 and IPv6 address by itself.

The OTMC 100 can be configured completely via the Web Interface using a computer. This way, no

manual intervention at the device itself will be required under normal circumstances.

5.2.1

Your computer must fulfill the following requirements to access the OTMC 100 Web Interface:

•

Network port configured for operation in the network the OTMC 100 is connected to.

•

OMICRON Device Browser installed (see chapter "The OMICRON Device Browser" on page 87).

•

Web browser installed (Windows Internet Explorer 8 or higher or Mozilla Firefox 3 or higher).

If you are accessing the OTMC 100 from a Mac or Linux operating system supporting

zeroconf, you can access the web interface of the OTMC 100 by entering

http://<hostname>.local to the address bar of your web browser. The default hostname is

the device serial number. The serial number is available on the type plate on the bottom side

of the OTMC 100 (labeled "SerNo").

5.2.2

Proceed as follows to access the OTMC 100 Web Interface:

1. Connect your computer to the network.

2. If necessary, install the OMICRON Device Browser on your computer. See chapter "The

OMICRON Device Browser" on page 87.

3. Launch the OMICRON Device Browser.

Connection, Access & Initial Setup

Table of Contents