Omicron Lab OTMC 100 User Manual page 44

Omicron lab antenna-integrated ptp grandmaster clocks
Hide thumbs Also See for OTMC 100:
Table of Contents

Advertisement

OTMC 100 Series User Manual
Minimum delay request
interval [s]
Peer mean path delay [ns]
Delay asymmetry [ns]
Profile id
Network protocol
Vlan ID
44
Displays the minimum permitted mean time interval between
successive Delay_Req messages. This value is determined and
advertised by a master clock based on the ability of the master. Only
available for PTP profile "Default E2E"!
This parameter is set in the PTP configuration (see page 67) .
Minimum delay request interval = 2
IEEE 1588-2008, clause 8.2.5.3.2.
Displays the estimate of the current one-way propagation delay on the
link computed using the peer delay mechanism. If the delay
mechanism is E2E, this value is zero. See IEEE 1588-2008, clause
8.2.5.3.3.
Displays the asymmetry delay. The asymmetry delay is defined to be
positive when the master-to-slave or responder-to-requestor
propagation time is longer than the slave-to-master or requestor-to-
responder propagation time. See IEEE 1588-2008, clause 7.4.2.
Time (master -> slave) = meanPathDelay + delayAsymmetry
Time (slave -> master) = meanPathDelay - delayAsymmetry
Displays the profile identity. The profile identity identifies the PTP
profile implemented by the port indicated by the
targetPortIdentity.portNumber member of the field.
See IEEE 1588-2008, clause 15.5.3.1.2.10.
Displays the network protocol selected for the Transport parameter in
the PTP configuration (see page 67) .
Possible values are "UDP_IP_V4" (transport via UDP packets over
IPv4), "UDP_IP_V6" (transport of the PTP packets via UDP over IPv6),
and IEEE_802_3 (transport via Ethernet packets according to
IEEE 802.3).
Displays the Vlan ID. The Power Profile according to
IEEE C37.238-2011 requires an IEEE 802.1Q VLAN tag. This value
represents the VID (VLAN Identifier) field (12 bits) within the TCI (Tag
Control Identifier). See IEEE C37.238-2011, clause 5.6. Only available
for Power Profile (OTMC 100p only).
This parameter is set in the PTP configuration (see page 67) .
Log min delay request interval
seconds, see

Advertisement

Table of Contents
loading

Related Products for Omicron Lab OTMC 100

Table of Contents