Table of Contents
Advertisement
OTMC 100 Series User Manual
4.3
Mounting Instructions
There are two possible ways for mounting the OTMC 100. Refer to the subsections below for detailed
mounting instructions.
Mast mounting using the delivered mast
mounting kit.
4.3.1
Mounting Instructions for Mast Mounting
The mast mounting kit delivered with the OTMC 100 contains the following parts:
•
1 mast clamp consisting of 2 clamping jaws and 4 fastening screws M6 x 110 with lock washers
•
2 clamping blocks and 4 fastening screws M6 x 16 with lock washers
•
1 connection pipe 20 x 300 mm
Proceed as follows:
Assemble the mast clamp and attach it to the mast
as shown in the figure.
The mast clamp is suitable for mast diameters of 25
to 70 mm.
Use a tightening torque of 5 Nm for the fastening
screws of the clamping block (1). The tightening
torque for the fastening screws of the mast clamp (2)
depends on the material and diameter of the mast.
16
Temporary mounting using the 1/4" BSW
(British Standard Whitworth) thread for
mounting on a stand, for example.
1
2
Advertisement
Table of Contents
