Mounting Instructions For Temporary Mounting Using The 1/4" Bsw Thread - Omicron Lab OTMC 100 User Manual

OTMC 100 Series User Manual
possible to mount the OTMC 100 on the
top of a vertically mounted connecting pipe,
as shown in the figure on the right.
4.3.2 Mounting Instructions for Temporary Mounting Using the 1/4" BSW
Thread
Screw the grub screw of the stand into the 1/4" BSW
(British Standard Whitworth) thread (1) on the base
plate of the OTMC 100 and tighten it sufficiently.
The threaded hole in the base plate is 6.5 mm deep.
Make sure not to screw in the grub screw too deep!
Assemble the delivered waterproof RJ45 connector
to the Ethernet cable according to the accompanying
assembly instructions and insert it to the RJ45
connector on the base plate of the OTMC 100. If
necessary, use suitable cable ties to fasten the
Ethernet network cable to the stand.
Do not move the OTMC 100 during operation. Changing the position of the OTMC 100
during operation causes time errors.
18
1