Assigning An Ip Address Manually; Viewing And/Or Exporting The System Log File - Omicron Lab OTMC 100 User Manual

Omicron lab antenna-integrated ptp grandmaster clocks

Hide thumbs Also See for OTMC 100:

Table of Contents

OTMC 100 Series User Manual

6.1.8

Assigning an IP Address Manually

The IP address of the OTMC 100 is usually assigned automatically. If a DHCP server is available in

the network, the IP address is assigned by the DHCP server. If not, the OTMC 100 automatically

selects and assigns an IP address on its own.

Assigning an IP address manually is only necessary if the automatic IP address assignment does not

work due to specific characteristics of the network.

1. Click the Configuration icon in the navigation bar of the Web Interface.

2. Click the Network icon of the Configuration section and display the IPv4 tab (or IPv6 if the

network supports IPv6).

3. Select Manual from the list box.

4. Enter the IP address, the Network mask, the Gateway address and the Name server address in

dot-decimal notation (e.g.: 192.168.1.100).

5. Click the Save button to upload and save your settings in the OTMC 100.

See also "Network Configuration Page" on page 58.

6.1.9

The log file contains all events logged by the system. Therefore, it may be helpful for the technical

support of OMICRON in case of problems.

Which types of events are actually logged by the system can be selected in the Log & Notifications

configuration (see page 76) .

1. Click the Status icon in the navigation bar of the Web Interface.

2. Click the Log Viewer icon to display the log file.

3. View the messages logged in the file. Error messages are displayed in red, warning messages are

displayed in orange, notice messages are displayed in black. All other messages are displayed in

gray.

4. By clicking Clear View you can clear the display of the Log Viewer page. This does not clear the

log file. Re-opening the Log Viewer page will again display all messages logged in the log file.

5. By clicking Export Log you can export the log file content to a text file (file extension .log).

The log file is cleared with each reboot of the OTMC 100 (see "Performing a reboot of the

OTMC 100" on page 28 or "Performing a reboot of the OTMC 100" on page 31). If the

maximum size of the log file is reached, the system automatically deletes old log file entries

in order to release memory space for new entries.

Table of Contents