Table of Contents
Advertisement
6.1.5
Performing a Factory Reset (Reset to Factory Defaults)
A factory reset can also be performed directly on the device (see "Operating Procedures
Performed at the Device" on page 31).
Resetting the device to the factory defaults may be necessary if you forgot your password, for
example.
1. Click the Tools icon in the navigation bar of the Web Interface.
2. Click the Device Control icon.
3. Click the Reset button next to Factory reset.
4. The OTMC 100 performs a reboot and resets all configuration settings to the factory defaults. The
device will be ready for operation again after approx. 15 s.
6.1.6
Creating a System Snapshot for Troubleshooting
A system snapshot contains the configuration settings and the log file. It thus provides important
information for the technical support in case of problems.
1. Click the Tools icon in the navigation bar of the Web Interface.
2. Click the Device Control icon.
3. Click the Download button next to System snapshot to download a system snapshot file.
6.1.7
Uploading New Software to the Device in Recovery Mode
Entering the recovery mode manually is only possible using the pushbutton on the device
(see "Operating Procedures Performed at the Device" on page 31).
The recovery mode is entered automatically if a software update performed via the Web Interface fails.
1. In recovery mode the device provides a rudimentary Web Interface solely allowing for the upload of
a software image.
2. Click the Browse... button to navigate to a suitable software image file.
3. Click the Update button to start the software update.
4. The update process may take several minutes. Do not disconnect the OTMC 100 or the computer
during this process.
5. The OTMC 100 automatically restarts after the software has installed completely.
Operating the OTMC 100
29
Advertisement
Table of Contents
