Troubleshooting; Typical Start-Up Problems; Unit Does Not Start-Up - Wine Guardian Through-the-Wall Installation, Operation And Maintenance Manual

Wine cellar cooling systems
Hide thumbs Also See for Through-the-Wall:
Table of Contents

Advertisement

Troubleshooting

BEFORE PROCEEDING, READ AND UNDERSTAND THE SAFETY INFORMATION CONTAINED
This section is intended as a diagnostic aid only. For detailed repair or parts
replacement procedures, contact a qualified service company. Check the
following table for some solutions before calling a service technician.

Typical Start-up Problems

Possible Cause
Incorrect thermostat or humidistat
Changed settings on the thermostat

Unit Does not Start-up

Thermostat light is off
Possible Cause
Voltage switch not in correct position
No power to outlet
Unit not plugged in
LCDI tripped
Thermostat light is on
Possible Cause
Thermostat is not set up properly
WARNING
IN THE SAFETY SECTION OF THE WINE GUARDIAN MANUAL.
IMPORTANT
Solution
Check the thermostat and humidistat setup for
the application. Read the thermostat
troubleshoot guidelines in the Thermostat
Installation and Operating Instructions.
A common problem is not waiting long enough
for the internal timers to complete their timed
delay. Allow 5 minutes for compressor to start.
Solution
Check position of voltage switch
Check circuit breaker and wiring
Plug in the unit
Reset
Solution
Check thermostat set up in the guide
41

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Through-the-wall wine cellar cooling systems

Table of Contents