Table of Contents
Advertisement
Hardware Installation
3.
Push each cable into its connector and rotate its lock into place.
4.
Connect the other end of each color-coded cable to the corresponding
output socket on the Cabinet I/O Panel.
5.
Push the cable into the connector and rotate the lock into place.
4.4 Monitor to Cabinet Control Cable Connection
The Control Cable connects the Cabinet and the Monitor.
1.
Connect the female end of the Control Cable to the 25-pin socket on
the Monitor Back Panel.
2.
Connect the male end of the Control Cable to
I/O Panel.
3.
Fix the Control Cable into place by tightening the captive screws on
each side of both plugs.
4.5 Monitor to Cabinet AC Power Cable Connection
The Monitor power outlet is located on the Cabinet Power Panel (see Figure 34).
This switched AC outlet is controlled by the Cabinet
1.
Connect the female end of the AC power cable to the
socket on the Monitor Back Panel.
2.
Connect the male end of the Monitor power cable to the AC outlet
labeled
4.6 IRIS Workstation to Serial Line Connection
The IRIS Workstation can be connected to a modem, a terminal or a printer
through a serial line attached to
Panel. The connection for each of these devices are slightly different. Each
physical device connection also has a corresponding UNIX software
configuration procedure. Sections 6.8, 6.9 and 6.10 describe these procedures.
Terminal Connection
1.
Attach an RS-232 cable from the ASCII terminal to
Port 4
the RS-232 interface for the IRIS Workstation serial ports. These are
Data Terminal Equipment (DTE) type RS-232 ports. If the ASCII
terminal is also DTE type, then a null modem is required for the
connection. If the terminal is Data Communication/Circuit Terminating
Equipment (DCE) type, then a simple connection can be made
without a null modem. The manual for the ASCII terminal should
have a specification of its RS-232 interface.
Version 1.0
on the Cabinet Power Panel.
Monitor
Port 2
on the Cabinet I/O Panel. Appendix H has a description of
IRIS WORKSTATION GUIDE
Power
,
or
Port 3
Port 4
on the Cabinet
Port 1
switch.
power
Input
on the Cabinet I/O
,
Port 2
Port 3
17
or
Advertisement
Table of Contents
