Appendix B:
There is no lost+found directory in the root directory of the file system; fsck
ignores the request to link a directory in lost+found. This will always invoke
the UNREF error condition in Phase 4. Check access modes of lost+found. See
fsck(1M) manual entry for further detail.
SORRY. NO SPACE IN lost+found DIRECTORY
There is no space to add another entry to the lost+found directory in the root
directory of the file system; fsck ignores the request to link a directory in
lost+found. This will always invoke the UNREF error condition in Phase 4.
Clean out unnecessary entries in lost+found or make lost+found larger. See fsck(1M)
manual entry for further detail.
DIR I=I1 CONNECTED. PARENT WAS I=I2
This is an advisory message indicating a directory inode I1 was successfully
connected to the lost+found directory. The parent inode I2 of the directory
inode I1 is replaced by the inode number of the lost+found directory. See
Section 4.4 and 4.2.2.
Phase 4: Check Reference Counts
This phase concerns itself with the link count information seen in Phase 2 and
Phase 3. This section lists error conditions resulting from unreferenced files,
missing or full lost+found directory, incorrect link counts for files, directories, or
special files, unreferenced files and directories, bad and duplicate blocks in files
and directories, and incorrect total free-inode counts.
UNREF
FILE
(RECONNECT)
Inode I was not connected to a directory entry when the file system was
traversed. The owner O, mode M, size S, and modify time T of inode I are
printed. See Section 4.2.2.
Possible responses to the RECONNECT prompt are:
reconnect inode I to the file system in the directory for lost files
YES
(usually
condition in Phase 4 if there are problems connecting inode I to
lost+found.
NO
ignore this error condition. This will always invoke the CLEAR
error condition in Phase 4.
Version 1.0
I=I
OWNER=O
This
lost+found).
IRIS WORKSTATION GUIDE
MODE=M
SIZE=S
may
invoke
the
63
MTIME=T
error
lost+found
Need help?
Do you have a question about the IRIS Workstation and is the answer not in the manual?