Programmable Configuration Options - Elo TouchSystems ET1229L Series User Manual

USB HID Keyboard Emulation Swipe Reader
Tk1 SS =
Tk2 SS =
Tk3 SS =
ES =
CR =
All data will be sent in upper case regardless of the state of the caps lock key on the keyboard. If
no data is detected on a track then nothing will be transmitted for that track. If an error is
detected on a track the ASCII character E will be sent in place of the track data to indicate an
error.
The card data format for all programmable configuration options is as follows:
[P11][P13][Tk1 SS][Tk1 Data][ES][LRC][P14][P5][P13][Tk2 SS][Tk2
Data][ES][LRC][P14][P5][P13][Tk3 SS][Tk3 Data][ES][LRC][P14][P5][P12]
where:
ES =
LRC =
P5 =
P11 =
P12 =
P13 =
P14 =
Tk1 SS =
Tk2 SS =
Tk3 SS =
All fields with the format P# are programmable configuration property numbers. They are
described in detail later in this document.

PROGRAMMABLE CONFIGURATION OPTIONS

This device has a number of programmable configuration properties. These properties are stored
in non-volatile EEPROM memory. These properties can be configured at the factory or by the
end user using a program supplied by MagTek. Programming these parameters requires low
level communications with the device. During normal device operation, the device acts like a
USB HID keyboard so the host operating system takes care of all low level communications with
12
% (7-bit start sentinel)
; (ISO/ABA 5-bit start sentinel)
@ (7-bit start sentinel)
+ (ISO/ABA start sentinel)
! (CA drivers licence start sentinel)
# (AAMVA start sentinel)
& (7-bit start sentinel)
? (end sentinel)
(carriage return) (0D hex)
? (end sentinel)
Longitudinal redundancy check character
Terminating character
Pre card character
Post card character
Pre track character
Post track character
% (7-bit start sentinel)
; (ISO/ABA 5-bit start sentinel)
P6 (7-bit start sentinel)
P8 (ISO/ABA start sentinel)
P7 (CA drivers licence start sentinel)
P9 (AAMVA start sentinel)
P10 (7-bit start sentinel)