Rear Facing Customer Display; Serial Customer Display; Usb Customer Display - Elo TouchSystems ET1229L Series User Manual

Rear Facing Customer Display

Serial Customer Display

The serial customer displays do not need drivers. To get an image on the
display:
Plug the DB-9 connector into serial port COM1 of computer.
1
Plug the RJ-45 cable into display.
2
In windows click on Start > Run
3
Enter cmd > OK
4
Type MODE COM1 96,N,8,1 > Enter
5
Type TYPE CON > COM1 > Enter
6
Type ELO > Enter
7
The display will show ELO.

USB Customer Display

Plug in the USB cable attached to the Customer Display unit. The New
Hardware Wizard dialog box will appear.
Choose Next and select "Search for the best driver for your device
1
(Recommended)" then choose Next.
When a list of search locations is displayed, place a checkmark on the drive
2
containing the driver package:
Touch Monitor Peripherals\Rear Facing Customer
Displays\Drivers\xxx\LCLD9.sys, where xxx is Win98 for a Windows 98 based
system or 2000 for a Windows XP/2000 based system.
Insert the disk into your drive. (If the driver files have been copied to your
3
hard drive or have been distributed on CD, place a checkmark on "Specify a
location" and browse to select the directory containing the driver files.)
Choose Next. Once the Customer Display driver has been detected choose
4
Next again.
Wait while driver files are copied to your computer.
5
Insert your Windows CD if prompted and choose Finish
6
2-26
E l o E n t u i t i v e T o u c h m o n i t o r U s e r G u i d e