Elo TouchSystems ET1229L Series User Manual page 150

12.1" lcd touchmonior with optional magnetic stripe reader, finger print reader and rear facing customer display
Hide thumbs Also See for ET1229L Series:
Table of Contents

Advertisement

write
Function
Data encode command.
Syntax
/write
Errors
/write
Encode is not supported on this device.
/write
The data field was in the incorrect format.
/write
The
write
/write
Device in wrong mode (e.g., if /read already issued)
/write
Error during write operation (e.g., on MT-95)
Remarks
The data field is in the following format:
[
an-data
%
an-data is alphanumeric data (ASCII characters ' ' to '_' (0x20 to 0x7f))
n-data is numeric data (ASCII characters '0' to '?' (0x30 to 0x3f))
The data should not contain the end sentinel character (
If the application sends data for an alphanumeric track that contains lowercase
characters (ASCII values beyond 0x60), they will be capitalized if
. To disable this and send the data as-is to the device, set the
1
to
. The three sub-sections of the data string represent the three tracks on the
0
magnetic card. The data for each track begins with a start sentinel character, which
defines both the track number and the data format for the track:
%
;
@
+
!
#
&
Note that any or all of the data may be missing, but the order of the data for the
tracks must always be in order (1, 2, 3). A missing track is interpreted as "don't
write" for the data encode command – that track will not be overwritten by the
encode operation.
The response sent for this command is:
status is
See the definitions of the status values in Appendix C. Status Codes.
Example
Encode tracks 1 and 2:
Command
Response
data
94<LF>
34<LF>
82<LF>
command was canceled.
45<LF>
60<LF>
][
n-data
|
a-data
?
;
?
@
identifies track 1 (7-bit alphanumeric)
identifies track 2 (5-bit numeric)
identifies track 2 (7-bit alphanumeric)
identifies track 3 (5-bit numeric)
identifies track 3 (CA Driver License)
identifies track 3 (alphanumeric, AAMVA)
identifies track 3 (7-bit alphanumeric)
if the encode succeeded and non-zero if it failed.
00
/write %B12345^TEST^0000?;12345?<LF>
/write
][(
n-data
|
an-data
?
+
?
#
?
status.
/write
00<LF>
Section 3. Commands
|
an-data
|
an-data)]
?
!
?
&
).
capitalize
property
capitalize
=
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Entuitive 1229l

Table of Contents