Track_Id_Enable Property - Elo TouchSystems ET1229L Series User Manual

memory so it will not change when the unit is power cycled. The value of this property, if any,
will be sent to the host when the host requests the device's USB endpoint descriptor. When this
property is changed, the unit must be power cycled to have these changes take effect for the USB
descriptor. If a value other than the default value is desired, it can be set by the factory upon
request. Examples follow:
Example Set POLLING_INTERVAL property Request (Hex):
Cmd Num
01
Example Set POLLING_INTERVAL property Response (Hex):
Result Code
00
Example Get POLLING_INTERVAL property Request (Hex):
Cmd Num
00
Example Get POLLING_INTERVAL property Response (Hex):
Result Code
00

TRACK_ID_ENABLE PROPERTY

Property ID:
Property Type:
Length:
Get Property:
Set Property:
Default Value:
Description:
id 0 T
Id 0 – Decodes standard ISO/ABA cards only
1 – Decodes AAMVA, CA DL/ID and 7-bit cards also
T 00 – Track Disabled
#
01 – Track Enabled
10 – Track Enabled/Required (Error if blank)
This property is stored in non-volatile EEPROM memory so it will not change when the unit is
power cycled. When this property is changed, the unit must be power cycled to have these
changes take effect. If a value other than the default value is desired, it can be set by the factory
upon request.
Data Len
02
Data Len
00
Data Len
01
Data Len
01
3
Byte
1 byte
Yes
Yes
95 (hex)
This property is defined as follows:
T T T T
3 3 2 2
Section 4. USB Communications
Prp ID Prp Value
02 0A
Data
Prp ID
02
Prp Value
0A
T
1 1
19