Ss_Tk2_7Bits Property; Ss_Tk3_Cadl Property - Elo TouchSystems ET1229L Series User Manual

Set Property:
Default Value:
Description:
mod c
mod 0 – Send c after card data
1 – Send c after each track
c 1-127 – 7 bit ASCII char code
0 – send nothing
This property is stored in non-volatile EEPROM memory so it will not change when the unit is
power cycled. When this property is changed, the unit must be power cycled to have these
changes take effect. If a value other than the default value is desired, it can be set by the factory
upon request.

SS_TK2_7BITS PROPERTY

Property ID:
Property Type:
Length:
Get Property:
Set Property:
Default Value:
Description:
2 encoded in 7 bits per character format. If the value is 0 no character is sent. If the value is in
the range 1 – 127 then the equivalent ASCII character will be sent.
This property is stored in non-volatile EEPROM memory so it will not change when the unit is
power cycled. When this property is changed, the unit must be power cycled to have these
changes take effect. If a value other than the default value is desired, it can be set by the factory
upon request.

SS_TK3_CADL PROPERTY

Property ID:
Property Type:
Length:
Get Property:
Set Property:
Default Value:
Description:
3 encoded in California drivers license format. If the value is 0 no character is sent. If the value
is in the range 1 – 127 then the equivalent ASCII character will be sent.
Yes
0D (hex) (carriage return)
This property is defined as follows:
c c c c
6
Byte
1 byte
Yes
Yes
40 (hex) '@'
This character is sent as the track 2 start sentinel for cards that have track
7
Byte
1 byte
Yes
Yes
21 (hex) '!'
This character is sent as the track 3 start sentinel for cards that have track
Section 4. USB Communications
c c
21