Windows Plug And Play Setup; Mounting - Elo TouchSystems ET1229L Series User Manual

USB HID Keyboard Emulation Swipe Reader

WINDOWS PLUG AND PLAY SETUP

On hosts with the Windows operating system, the first time the device is plugged into a specific
USB port, Windows will pop up a dialog box, which will guide you through the process of
installing a device driver for the device. After this process is completed once, Windows will no
longer request this process as long as the device is plugged into the same USB port. The device
driver that Windows will install for this device is the driver used for HID keyboard devices and it
is part of the Windows operating system. When the dialog box pops up, follow the instructions
given to you in the dialog box. Sometimes Windows will find all the files it needs on its own
without giving you any prompts. Other times Windows will need to know the location of the
files it needs. If Windows prompts you for the file locations, insert the CD that was used to
install Windows on your PC and point Windows to the root directory of the CD. Windows
should find all the files it needs there.

MOUNTING

The Reader may be mounted with screws or fastening tape as described below.
The Reader should be mounted such that the bottom (mounting
side) is not exposed to the user. This is because the mounting side
of the reader may be susceptible to electrostatic discharge.
1. The Reader can be mounted on a surface in three ways:
•
By two screws through the surface attached to the bottom of the unit and running
the cable on the top of the surface;
•
By two screws through the surface attached to the bottom of the unit and by
drilling a hole in the surface for the cable and running the cable through the hole;
•
By attaching the unit to the surface with fastening tape and running the cable on
the top of the surface.
The two mounting inserts are 3 mm diameter; 0.5 mm pitch; 6.4
mm deep. The length of the screws used depends on the mounting
surface thickness and the thickness of washers (if used).
The mounting dimensions are shown in Figure 2-2. Determine the method of mounting
required.
6
Caution
Note