Pre_Card_Char Property; Post_Card_Char Property - Elo TouchSystems ET1229L Series User Manual

Description:
3 encoded in 7 bits per character format. If the value is 0 no character is sent. If the value is in
the range 1 – 127 then the equivalent ASCII character will be sent.
This property is stored in non-volatile EEPROM memory so it will not change when the unit is
power cycled. When this property is changed, the unit must be power cycled to have these
changes take effect. If a value other than the default value is desired, it can be set by the factory
upon request.

PRE_CARD_CHAR PROPERTY

Property ID:
Property Type:
Length:
Get Property:
Set Property:
Default Value:
Description:
character is sent. If the value is in the range 1 – 127 then the equivalent ASCII character will be
sent.
This property is stored in non-volatile EEPROM memory so it will not change when the unit is
power cycled. When this property is changed, the unit must be power cycled to have these
changes take effect. If a value other than the default value is desired, it can be set by the factory
upon request.

POST_CARD_CHAR PROPERTY

Property ID:
Property Type:
Length:
Get Property:
Set Property:
Default Value:
Description:
character is sent. If the value is in the range 1 – 127 then the equivalent ASCII character will be
sent.
This property is stored in non-volatile EEPROM memory so it will not change when the unit is
power cycled. When this property is changed, the unit must be power cycled to have these
changes take effect. If a value other than the default value is desired, it can be set by the factory
upon request.
This character is sent as the track 3 start sentinel for cards that have track
11 (0B hex)
Byte
1 byte
Yes
Yes
0
This character is sent prior to all other card data. If the value is 0 no
12 (0C hex)
Byte
1 byte
Yes
Yes
0
This character is sent after all other card data. If the value is 0 no
Section 4. USB Communications
23