Property
Access
R/W
enc_key
R/W
enc_key_sn
R/W
enc_mode
R/W
entry_echo
R/W
entry_len
R/W
entry_tout
R/W
events_on
R/W
invalcmdrsp
R/W
key_parity
R
lasterr
R/W
max_pin_len
R/W
msg1 - msg4
Encryption key to use for the next encryption process (IntelliPIN):
for Master key
M
for Session key
S
for lower working keys
0-3
for upper working keys
A-J
Serial number of encryption key. Used to specify key serial
number for activating/deactivating PIN encryption in MSK mode
and to return the key serial number in DUKPT mode. The key
serial number is specified in clear text (IntelliPIN).
Current encryption mode –
Specifies how to display the characters when entered from the
keypad on the LCD screen (IntelliPIN):
•
empty value to display as entered
•
(minus) to suppress display
•
$ to display as amount
The value of this property affects the operation of the
command. By default this property is empty.
key_string
Maximum number of characters (1-32) to be collected with the
read key_string
property converts to a length of 1. (IntelliPIN)
Entry timeout: number of seconds (15-255) to wait for keypad
input. (IntelliPIN)
Set to
to enable unsolicited event notifications. The default is
1
(PPINSERT)
Invalid command response: set to
commands (useful during program development). This is set to
(disabled) by default.
Set to
to enable parity check on encryption keys. (IntelliPIN)
1
Status from the last command sent to the driver. A successfully
executed command will reset this value to
useful for checking the operation of the
each
the response to
set,
Maximum PIN length (IntelliPIN):
•
1 – 16 for
ibm
•
4 – 12 for
ansi
Messages to show on LCD screen with various commands.
– used by the
msg1
– used by the
msg2
– used by the
msg3
– used by the
msg4
To specify leading spaces, use
for more information. (IntelliPIN)
Description
or
msk
dukpt
command. An empty value (default) for this
to enable responses to invalid
1
set
get lasterr
format (IBM 3624)
format (ANSI 9.8)
and
read
display
and
display
read pin
command
read pin
and
key_press
key_string
. See the
\x20
Section 2. Properties
(IntelliPIN).
read
. This property is
0
commands. After
should be
.
0
commands
commands
operations
command
display
.
0
0
13