Figure 4-2. Rear View Of Intellitouch Touchscreen With Mounting Materials - Elo TouchSystems IntelliTouch Ultra Product Manual

Creating enough space between the CRT and the bezel to accommodate the Creating enough space between the CRT and the bezel to accommodate the
• •
touchscreen and the transducers. Adequate spacing can normally be accom- touchscreen and the transducers. Adequate spacing can normally be accom-
plished by: 1) trimming or milling the inside of the bezel; 2) using spacers to plished by: 1) trimming or milling the inside of the bezel; 2) using spacers to
move the CRT back in the chassis; 3) using spacers to move the bezel away move the CRT back in the chassis; 3) using spacers to move the bezel away
from the touchscreen. A combination of moving the CRT back with spacers from the touchscreen. A combination of moving the CRT back with spacers
and trimming the bezel is the usual solution. and trimming the bezel is the usual solution.
The type of seal to be used between the touchscreen and the display bezel. The type of seal to be used between the touchscreen and the display bezel.
• •
Spacers must be placed between the mounting ears of the CRT and the mounting Spacers must be placed between the mounting ears of the CRT and the mounting
posts in the bezel of the display to prevent the touchscreen from being clamped posts in the bezel of the display to prevent the touchscreen from being clamped
between the CRT and the bezel. The last three considerations listed above should between the CRT and the bezel. The last three considerations listed above should
determine the nominal thickness of the spacers to be used. determine the nominal thickness of the spacers to be used.
Many monitors will have sufficient space in the bezel to allow the touchscreen Many monitors will have sufficient space in the bezel to allow the touchscreen
face to rest against the lip of the bezel, with the lip touching the active region of face to rest against the lip of the bezel, with the lip touching the active region of
the touchscreen. However, the transducers should not be in contact with the bezel. the touchscreen. However, the transducers should not be in contact with the bezel.
Assuming double-sided tape is used to attach the touchscreen to the CRT, the Assuming double-sided tape is used to attach the touchscreen to the CRT, the
final spacing will be determined by the type of seal to be used. See final spacing will be determined by the type of seal to be used. See
page 47, for an explanation of sealing methods. page 47, for an explanation of sealing methods.
Double-sided tape and foam sealing tape are included in the Touchscreen Double-sided tape and foam sealing tape are included in the Touchscreen
Installation Kit (P/N UK0001). The following steps assume you will use these Installation Kit (P/N UK0001). The following steps assume you will use these
materials to mount the touchscreen to the CRT. materials to mount the touchscreen to the CRT.

Figure 4-2. Rear View of IntelliTouch Touchscreen with Mounting Materials

Figure 4-2. Rear View of IntelliTouch Touchscreen with Mounting Materials
Mounting the Touch Mounting the Touchscreen screen
Sealing Sealing
35 35
, ,